Measuring for a Patio Door Frame

Before you purchase a patio door frame, you need to be certain about the measurements you need to fit your space. The last thing you want to do is to purchase a patio door and have it not fit. Most patio doors feature standard measurements but you will also run into doors that are made for custom doorways. In order to purchase a correctly-sized patio door, you’ll want to take several measurements:

Inner Vertical Frame: Measure from the top of the subfloor to the top of the inside portion of the frame.

Inner Horizontal Frame: Measure the length you desire between two studs in the wall while keeping the tape measure level. Make sure you add two inches to account for the frame.

Two Vertical Measurements: Make a vertical measurement on either side of the door and make sure that the figures are the same.

Two Horizontal Measurements: Measure the length at the bottom and the top and ensure that the two numbers match.

If you are completing a do it yourself job by adding your patio doors, there’s a chance that you won’t be able to find patio doors that are an exact match for your required dimensions. In this case, it’s better to choose a patio door that is slightly too small rather than slightly too big. This is because it’s more difficult to cut into the wall to make additional space than it is to add to the frame to make it fit the space. If you are having difficulty with making your patio door frame fit, consult a contractor for a measurement.

Bio: This article was penned by Eto Doors, a top seller of home and commercial doors. Check out educational Eto Doors reviews and see their full range of doors for sale at the Eto Doors website.

Are Pocket Doors Right For You?

Interior doors are very useful in keeping your home neat and organized. However, finding space for doors and that swing out can be difficult, especially in areas where space is at a premium. Linen closets, pantries and powder rooms are just three examples of small spaces in tight locations that would be enhanced by having doors but where installing a full door might be impossible.

If you are struggling with this problem, you should consider pocket doors as an alternative to full swinging doors. Unlike traditional doors, pocket doors slide into the wall instead of swinging out. This can lead to a major savings in space needed to install a door. If you have a three foot wide door, for example, you might need up to nine feet of space to fully open and close it. When you install a pocket door instead, this is no longer a problem.

Pocket doors are purchased as kits that make them very easy to install. This kit will typically include nylon rollers, box tracks, door hangers and floor brackets. Most standard pocket kits handle pocket doors that weigh up to 125 pounds. Some decorative pocket doors will weigh up to 200 pounds, so you’ll need to purchase a specialty kit for these doors.

Before you think about installing a pocket door, you’ll need to evaluate the space where it will be used. If it is going to be installed in a wall that has electrical wires or is load-bearing, you likely won’t be able to make it work. If any of the door edges are unfinished, you’ll need to seal them first. You’ll also want to add insulation on top of the door to prevent a loss of heat.

Eto Doors has penned this article. Visit www.etodoors.com to see the latest styles of interior and exterior doors available from Eto Doors. You can also read helpful Eto Doors reviews and get creative ideas for your home.